The IPv4 Settings tab allows you to configure the method used to connect to a network, to enter an
IP address, DNS and route information as required.
4. To assign the IPaddress manually, select the Method option Manual.
5. In the Addresses section, click the Add button.
6. Enter the new IP Address, Netmask and IPaddress of the Gateway, then click Save.
After running the script, you will need to reboot. See section "First Install" on page 1.
Manually Changing the Server's Hostname
To change the server's hostname after it was set during installation, proceed as follows:
1. Open a terminal window.
2. Type the following command:
sudo nmtui
INSTALLATION AND CONFIGURATION MANUAL
Xeebra |5. Configuration| 17
To Next Page
Loading...