The NTP Configuration script opens in a terminal window. If the server has not been configured yet
as an NTPclient, the following message will be displayed: 'This machine is not configured for time
synchronization'.
2. Select 1 and press ENTER.
3. Add the IP address of the NTP server you want to use as reference point and press ENTER to
continue.
The Xeebra services are stopped, the Time Service is installed and the Xeebra services are restarted
again.
You are prompted to clear all tracks.
4. Press ENTERto continue.
Information is displayed about the synchronization status of the server, e.g. synchronization with the
NTPserver, UTC reference time, etc. You also see confirmation that the server is now configured to
use a time server.
When you start the ingest on a server, there is a check to see if frames aleady exist on the storage that
will be used. If there are any, the ingest will not start and a message is shown: 'Ingest could not start, a
time stamp in the future exists on the storage. Please clear all tracks'.
26| March 2022 | Issue 2.6.G
To Next Page
Loading...
Need help?
General
