5. In the Unit Data tab, select the Change Endpoints button.
6. Use the drop-down menu to select an endpoint with a keyboard component but without a PI
Consumer component.
This will disconnect the device from MW3.1 and it is now safe to plug it into a Linux box for use.
7. If you ever need to reprogram the X-keys, just plug it in, launch MW3.1, and follow the prompts, but
make sure you change the endpoint (Step 6) when you finish.
Default keypad shortcuts can be found in the Xeebra user manual appendices.
INSTALLATION AND CONFIGURATION MANUAL
Xeebra |5. Configuration| 33
To Next Page
Loading...
Need help?
General
