To remove either running board, there are a total of seven securing screws. Five of the securing screws
are located where the running board meets the black floorboard. To see these securing screws, you will
have to remove the floor mat.
There are two more screws that secure
the running board to the mud guard.
One is facing the ground, and the other
is in a recessed hole on the mud guard.
Turning the wheel in either directly will
assist with removing the screw in the
recessed hole.
The final screw to remove is where the running board
connects to the front body shroud. Removing this final
screw will allow for the running board to be removed.
Slide the running board away from the floorboard to
avoid breaking the running board tabs.
Front Wheel Fender
To Next Page
