Next, unplug the connection for each side taillight wiring from
the wire harness.
Then remove the seat latch cable end pod from the seat latch
mechanism.
Once the cables end catch
has been removed, the seat latch cable housing can be pulled
away from its mounting
point.
Next to remove are the six
bolts and screws on the
floorboard that secure the
main body shroud to the
frame, and floorboard.
There are two more bolts securing the main body to the frame in the
back. They are located on the back panel, where the rear bumper
portion secures the frame, right underneath the license plate cover.
To Next Page
