Motor Oil - The EW-36 uses 5W-30 motor oil (synthetic or non-synthetic). If completely empty, refill the
motor with up to ½ quart of oil.
Wire Harness and Brake Cable Replacement
Wire Harness - The wire harness runs the length of the machine, from front to back. Replacing the wire
will require removing the seat, storage box underneath the seat, main body shroud, headlight body
panel, and front sliding plate.
Running the replacement harness next to the
previous harness is recommended to avoid
mismatching the wire harness connectors. As you
unplug one connection from the old harness, plug
the connector immediately into the new harness's
identical connector to avoid confusion.
Once all connections have been replaced, remove the old wire harness and the entirety its mounts. Zip
tie the new harness to the frame at the same points the old harness was mounted. Test that all
functions of the scooter are working as they should prior to reinstalling the body paneling.
To Next Page
