Front Brake Cable - Removing the headlight body panel will be necessary to replace the front brake
cable. Once done, the brake handle cable mount will be exposed. Before you remove the cable from the
handle, first remove the adjusting nut, spring, and mounting spacer.
Once the brake cable hardware is removed, the brake line will have no tension. Remove the cable from
the brake handle next by turning the barrel adjuster with securing washer to the point where the
adjuster and washers cut outs match up with the cut out for the brake handle.
Once lined up, pull the brake
cables housing away from the
handle until the cable and
cable housing can be slid out
from the handles housing.
To Next Page
