Excel TS2501 - Proper Use; Technical Data

9
C.
Handle...........
1
D.
Miter Gauge...........
1
E.
Rip Fence..............
1
F.
Locking Lever..............
1
G.
Screws & Nut.s..............
16
H.
Closed End Wrench ..............
2
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger
of swallowing or suffocating !
5. Proper use
The bench-type circular saw is designed for the
slitting and cross-cutting (only with the cross
stop) of all types of timber commensurate with
the machine‘s size. The equipment is not to be
used for cutting any type of round wood.
The equipment is to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user / operator and not
the manufacturer will be liable for any damage
or injuries of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the machine is used in commercial,
trade or industrial businesses or for equivalent
purposes.
The equipment is to be operated only with
suitable saw blades (saw blades made of HM or
CV) It is prohibited to use any type of HSS saw
blade and cutting-off wheel.
To use the equipment properly you must also
observe the safety information, the assembly
instructions and the operating instructions to be
found in this manual.
To use the equipment properly you must also
observe the safety information, the assembly
instructions and the operating instructions to be
found in this manual.
All persons who use and service the equipment
have to be acquainted with these operating
instructions and must be informed about the
equipment‘s potential hazards. It is also
imperative to observe the accident prevention
regulations in force in your area. The same
applies for the general rules of health and safety
at work.
The manufacturer will not be liable for any
changes made to the equipment nor for any
damage resulting from such changes. Even
when the equipment is used as prescribed it is
still impossible to eliminate certain residual risk
factors.
The following hazards may arise in connection
with the machine‘s construction and design:
• Contact with the saw blade in the uncovered
saw zone.
• Reaching into the running saw blade ( cut
injuries).
• Kick-back of workpieces and parts of
workpieces.
• Saw blade fracturing.
• Catapulting of faulty carbide tips from the saw
blade.
• Damage to hearing if essential ear-muffs are
not used.
• Harmful emissions of wood dust when used in
closed rooms.
6. Technical data
AC motor ........................... 220- 240V ~ 50Hz
Power P .......... S1 1800W,
.......... S6 25% 2000 W
Idle speed n
0
................................. 5000 min
-1
Cutting-off wheel ............
........... Ø 250 x Ø16 - 30 x 2 - 4 mm
Number of teeth ................................. 24 - 60
Table size ................................ 583 x 563mm
Table width extension, left& right ......... ........
583 x 165 mm