Excel TS2501 - Safety Instructions for the Handling of Saw Blades

7
j) Make sure that the saw blade is installed to
rotate in the proper direction. Do not use grinding
wheels, wire brushes, or abrasive wheels on a
table saw. Improper saw blade installation or use of
accessories not recommended may cause serious
injury.
3. Safety Instructions For The
Handling of Saw Blades
1 Only use insertion tools if you have
mastered their use.
2 Observe the maximum speed. The
maximum speed specified on the insertion tool
may not be exceeded. If specified, observe the
speed range.
3 Observe the motor / saw blade direction of
rotation.
4 Do not use any insertion tools with cracks.
Sort out cracked insertion tools. Repairs are not
permitted.
5 Clean grease, oil and water off of the
clamping surfaces.
6 Do not use any loose reducing rings or
bushes for the reducing of holes on saw blades.
7 Make sure that fixed reducer rings for
securing the insertion tool have the same
diameter and have at least 1/3 of the cutting
diameter.
8 Make sure that fixed reducer rings are
parallel to each other.
9 Handle insertion tool with caution. They
are ideally stored in the originally package or
special containers. Wear protective gloves in
order to improve grip and to further reduce the
risk of injury.
10 Prior to the use of insertion tools, make
sure that all protective devices are properly
fastened.
11 Prior to use, make sure that the insertion
tool meets the technical
requirements of this electric tool
and is properly fastened.
12 Only use the supplied saw blade for
sawing operations in wood, materials similar to
wood, plastics and non-ferrous metals (except for
magnesium and alloys containing magnesium).