Exerpeutic 1000 - Assembly Instructions; Assembly Step 1: Stabilizer Installation

Step 1
Place the magnetic treadmill in the upright position.
Remove six Washers (37) and six Bolts (40) from the Left/Right Stabilizer
Tubes (3L, 3R). Remove bolts with the 5# Allen Wrench with Phillips
Screwdriver provided.
Install both Left/Right Stabilizer Tubes (3L, 3R) to the Stabilizer (4) by
inserting both Left/Right Stabilizer Tubes (3L, 3R) into the Stabilizer (4),
using six Washers (37) and six Bolts (40) that were removed. Tighten bolts
with the 5# Allen Wrench with Phillips Screwdriver provided.
ASSEMBLY
8
Tool:
Allen Wrench with Phillips Screwdriver 5#