What to do if my Exerpeutic 97670 Treadmill will not start?
If your Exerpeutic Treadmill won't start, here's what to check: 1. Ensure the treadmill is plugged into a grounded outlet. 2. Make sure the safety tether key is correctly installed on the monitor. 3. Check your house circuit breaker and reset or replace the fuse if it has tripped. 4. Verify that the ON/OFF switch on the treadmill is in the ON position.
Why is the running belt slipping on my Exerpeutic 97670?
If the running belt on your Exerpeutic Treadmill is slipping, it could be due to: 1. The running belt not being tight enough. Solution: Adjust the running belt tension. 2. The drive belt not being tight enough. Solution: Adjust the drive belt tension.
What to do if the running belt hesitates when stepped on, on my Exerpeutic Treadmill?
If the running belt on your Exerpeutic Treadmill hesitates when you step on it, there are a couple of potential reasons: 1. Not enough lubrication on the running deck. Apply silicone lubricant to resolve this. 2. The running belt might be too tight. Try adjusting the running belt tension.
Details on proper electrical grounding for safe operation and risk reduction.
Instructions for using the treadmill in the quick start mode.
Step-by-step guide for operating the treadmill's computer console.
Instructions on how to adjust the treadmill's running belt for optimal performance.
Guidelines for cleaning the treadmill and proper storage procedures.
Common problems and their solutions for the treadmill.
General| Brand | Exerpeutic |
|---|---|
| Model | 97670 |
| Category | Treadmill |
| Language | English |
To Next Page
