Need help?Do you have a question about the EXFO MAX-800 Series and is the answer not in the manual?
General| Brand | EXFO |
|---|---|
| Model | MAX-800 Series |
| Category | Test Equipment |
| Language | English |
Lists critical safety warnings regarding fiber installation, controls, unit usage, and accessories.
Details precautions for unit installation, including environmental, electrical, and user serviceability.
Simulates and qualifies SLA parameters for network services.
Allows Ethernet throughput, back-to-back, frame loss, and latency testing.
Allows Ethernet Layer 1-4 traffic generation and Bit Error Rate analysis.
Allows configuring physical port and signal interface structure for transport tests.
Details pattern settings for BERT and Unframed BERT tests.
Explains EtherBERT and Unframed BERT test configurations.
Allows configuration of MAC, IP, and UDP parameters for frames.
Allows configuration of enabled subtests within RFC 2544.
Configures general service parameters like check boxes, service name, and direction.
Supports individual service configuration, including selection and activation.
Describes signal parameters for Optical and Electrical interfaces.
Allows selection of framing for DSn/PDH transmission.
Configures OTN signal parameters like FEC, Scrambler, and OPU tributary ports.
Configures SONET/SDH signal parameters, including synchronization status and path mappings.
Displays current and history alarms/errors with background color indicators.
Details Ethernet alarms like Link Down, Local Fault, Remote Fault, Hi-BER.
Configures Committed/Excess burst parameters for services.
Configures Committed/Excess steps for ramp tests.
Displays SLA parameters and metrics for service performance evaluation.
Provides a summary of cable test results, including status, wire map, and propagation delay.
Displays the result summary for EtherSAM test, including service configuration and performance test status.
Displays summary of RFC 2544 test, including start time and test recovery.
Controls QSFP28 transceiver settings, including power class and pin status.
Configures PCS/Logical lane mapping and skew values for parallel interfaces.
Configures BFD parameters, including IP addresses, intervals, and session state.
Validates integrity of overhead bytes in OTN signals.
Allows adjustment of pointer values for STS/AU and VT/TU paths.
Measures Round Trip Delay for network paths and interactive communication.
Scans for and connects to EXFO Datacom remote units or third-party devices.
Injects alarms/errors based on configured settings.
Provides capability to loop back Ethernet frames/packets.
Contains information about the current test, setup, and results; allows saving reports.
Starts or stops tests manually and enables traffic generation.
Lists common problems and their solutions before contacting technical support.
To Next Page
