6
English
Connecting an external device via the AUX IN jack
1. Turn thespeaker on by setting the[ OFF/ON ] switch (13) to theON position.
2. Connect a3.5 mm audio cable between theexternal audio device and
thespeaker’s AUX-IN jack (10). The speaker will automatically reset to receive
theAUX IN signal. This will be indicated by theAUX-IN LED indicator (2) which will
be lit asolid green.
3. Start and check for proper playback from theexternal device.
4. Adjust thevolume both on thedevice and speaker to achieve thedesired volume level.
Note:
• Once theexternal device is connected via theAUX IN jack, controlling playback
using thespeaker’s control panel will not be possible.
• When anexternal device is connected via theAUX IN jack, any existing Bluetooth
connection will be severed. When the3.5 mm audio cable is pulled out of theAUX
IN socket any previously active Bluetooth connection will automatically be resumed.
Care and maintenance
• Turn off thespeaker and unplug its adaptor from thewall socket before cleaning.
• Clean theproduct using alightly moistened cloth. Use only mild cleaning agents,
never solvents or corrosive chemicals for cleaning.