16
CAUTION
POTENTIAL HAZARD
♦ Machine can spin very rapidly by
positioning one lever too much ahead of
the other.
WHAT CAN HAPPEN
♦ Operator may lose control of the
machine, which may cause damage to
the machine or injury.
HOW TO AVOID THE HAZARD
♦ Use caution when making turns.
♦ Slow the machine down before making
sharp turns.
3.1.3 Tracking Adjustment Knob: Located under the seat on the LH pump control link.
Rotating this knob allows fine tuning adjustments so that the machine tracks straight
with the drive levers in the full forward position.
Stop machine and wait for all moving parts to stop. Engage park brake. Unhook seat
latch and tilt seat forward to gain access to the tracking knob. Rotate the knob
counter-clockwise (as viewed from the rear of the machine) to cause the machine to
track more to the right and clockwise to cause the machine to track more to the left.
Adjust in quarter-turn increments until the machine tracks straight. Check that the
machine does not creep when in neutral with the park brakes disengaged.
IMPORTANT: Do not rotate the knob too far, as this may cause the machine to
creep in neutral. Refer to section 4.2.11 for control linkage adjustment.
3.1.4 PTO Engagement Switch
: Located on the right fuel tank.
Switch must be pulled out to the “ROTATE” position to engage the blades. Switch
is pushed in to the “STOP” position to stop the blades.
3.1.5 Choke Control
: Located on the right fuel tank.
Choke is used to aid in starting a cold engine. Moving the choke lever forward will
put the choke in the “ON” position and moving the choke lever to the rear, to the
detent, will put the choke in the “OFF” position. DO NOT run a warm engine with
choke in the “ON” position.
3.1.6 Throttle Control
: Located on the right fuel tank.
Throttle is used to control engine speed. Moving throttle lever forward will increase
engine speed and moving throttle lever to the rear will decrease engine speed.
Moving the throttle forward into the detent is full position.
3.1.7 Brake Lever
: Located on left side of the console. The brake lever engages a
parking brake on the drive wheels.
Pull the lever up and rearward to engage the brake.
Push the lever forward and down to disengage the brake.
The unit must be tied down and brake engaged when transporting.
3.1.8 Ignition Switch
: Located on the right fuel tank.
The ignition switch is used to start and stop the engine. The switch has three
positions “OFF”, “ON” and “START”. Insert the key into switch and rotate
clockwise to the “ON” position.
Rotate clockwise to the next position to engage the starter (key must be held
against spring pressure in this position).
To Next Page
Loading...
