Exmark STARIS S Series

Questions and Answers

M
Michael GreenAug 16, 2025
Why won't my Exmark STARIS S Lawn Mower engine start?
- R
  Robin ThompsonAug 16, 2025
  If your Exmark Lawn Mower engine isn't starting, starts with difficulty, or won't stay running, several factors could be at play. First, ensure both fuel tanks are full and the fuel shutoff valve is open. For a cold engine, position the choke to 'ON,' or 'OFF' for a warm one, with the throttle midway between 'SLOW' and 'FAST'. Check and replace the fuel filter if it's dirty. Inspect the air cleaner, cleaning or replacing the element as needed. Ensure the spark plug wire is connected, and clean, adjust, or replace the spark plug if faulty. Also, verify electrical connections are secure and free of corrosion. If the MIL illuminates and blinks or the issue persists, it is best to contact an Authorized Service Dealer.
R
Robert MeyersAug 19, 2025
What to do if the Exmark Lawn Mower starter does not crank?
- L
  llarsonAug 19, 2025
  If the starter on your Exmark Lawn Mower isn't cranking, make sure the PTO is disengaged and the speed control levers are in the neutral position. Check that the battery has a full charge. Inspect the electrical connections for corrosion, looseness, or faults, cleaning the terminals and reconnecting them. Replace any blown fuses. If the neutral LCD indicator doesn't illuminate, check the reed switch. If these steps don't resolve the issue, it is best to contact an Authorized Service Dealer, as the relay or switch may be defective.
C
Curtis PerezAug 21, 2025
Why is my Exmark STARIS S engine losing power?
- B
  Bruce WrightAug 22, 2025
  If your Exmark Lawn Mower engine is losing power, first reduce the ground speed if the engine load is excessive. Then, check and clean or replace the air cleaner element if it's dirty. Ensure the oil level in the crankcase is adequate by adding oil if it is low. Remove any obstructions from the engine's cooling fins and air passages. Clean or replace the fuel cap if the vent hole is plugged. Replace the fuel filter if it's dirty. If the problem persists, it is best to contact an Authorized Service Dealer, as there may be dirt, water, or stale fuel in the fuel system.
R
reyesdavidAug 25, 2025
What causes an Exmark STARIS S engine to overheat?
- K
  Karen CobbAug 25, 2025
  If your Exmark Lawn Mower engine is overheating, first reduce the ground speed if the engine load is excessive. Make sure that the oil level in the crankcase is not low; add oil if needed. Clear any obstructions from the cooling fins and air passages to ensure proper ventilation.
J
Joseph Cuevas IIAug 27, 2025
What to do if Exmark STARIS S blades do not rotate?
- J
  Jeffrey HallAug 27, 2025
  If the blades on your Exmark Lawn Mower are not rotating, check the drive belt for damage and replace if necessary; then install it, ensuring the adjusting shafts and belt guides are correctly positioned. Install a new deck belt if the current one is worn, loose, or broken. Install the deck pulley and check the idler pulley, idler arm, and spring for correct position and function. Replace the spring if it's broken or missing. If the issue persists, it is best to contact an Authorized Service Dealer, as the electric clutch may be damaged.
G
Gary QuinnAug 30, 2025
Why does my Exmark STARIS S pull left or right?
- M
  Mr. Robert BarronAug 31, 2025
  If your Exmark Lawn Mower pulls to the left or right when the levers are fully forward, adjust the tire pressure in the drive tires to the correct level.
M
Michael CampbellSep 3, 2025
How to fix uneven cutting height on my Exmark STARIS S Lawn Mower?
- J
  Jeffrey PowellSep 3, 2025
  If you notice an uneven cutting height with your Exmark Lawn Mower, start by sharpening the blades or installing new ones if they are bent. Ensure the mower deck is level from side-to-side and front-to-rear. Clean the underside of the mower deck. Adjust the tire pressure in the drive tires to the correct level. If the tips of adjacent blades are at an uneven cutting height, replace blades, spindles and (or) check for damage to mower deck. If the issue continues, it is best to contact an Authorized Service Dealer, because the blade spindle might be bent.
C
Connie YoungSep 6, 2025
Why is my Exmark STARIS S Lawn Mower vibrating abnormally?
- W
  Wayne FieldsSep 6, 2025
  If your Exmark Lawn Mower is experiencing abnormal vibration, inspect the cutting blades for bending or imbalance, and install new ones if necessary. Tighten the blade mounting bolt and the engine mounting bolts. Also, tighten any loose engine, idler, or blade pulleys. Install new belt if the current one is damaged. If the issue persists, it is best to contact an Authorized Service Dealer, as the engine pulley or blade spindle may be damaged or bent.
C
crystalmortonSep 8, 2025
Why does my Exmark STARIS S Lawn Mower not drive?
- V
  Valerie RobinsonSep 8, 2025
  If your Exmark Lawn Mower isn't driving, first ensure the bypass valve is tightened securely. If that's not the issue, inspect the drive or pump belt for wear, looseness, or breakage and change the belt. Also, check if the drive or pump belt is off a pulley and change the belt.
T
Timothy ZimmermanSep 12, 2025
What causes the clutch on my Exmark STARIS S Lawn Mower to not engage?
- B
  Bryan MyersSep 12, 2025
  If the clutch on your Exmark Lawn Mower won't engage, begin by replacing the fuse. Then, check the coil resistance, battery charge, charging system, and wiring connections, replacing if necessary. If the coil is damaged, replace the clutch. Repair or replace the clutch lead wire or electrical system if there is inadequate current supply, and clean the connector contacts. If the rotor/armature airgap is too large, remove a shim or replace the clutch.