Exmark Turf Tracer TT20KCE

Questions and Answers

G
Gabriel LaneAug 15, 2025
What to do if the starter does not crank on my Exmark Turf Tracer TT20KCE?
- C
  Curtis BrownAug 15, 2025
  If the starter on your Exmark Lawn Mower isn't cranking, make sure the PTO is disengaged. Also, ensure the speed control lever is in the neutral lock position and that you depress the OPC levers. Check if the battery needs charging, and inspect all electrical connections for corrosion or looseness, cleaning and reconnecting them as needed. Finally, check the fuse and replace it if it's blown. If the issue persists, it could be a defective relay or switch, and you should contact an Authorized Service Dealer.
G
George CarterAug 18, 2025
Why Exmark Turf Tracer TT20KCE Lawn Mower engine will not start?
- J
  jonathansanchezAug 18, 2025
  If your Exmark Lawn Mower engine won't start, starts hard, or fails to keep running, first ensure the fuel tank isn't empty and the fuel shutoff valve is open. Check that the throttle and choke are in the correct positions. Replace the fuel filter if it's dirty and clean or replace the air cleaner element if it's dirty. Inspect electrical connections, ensuring they are clean and properly connected. Also, check the spark plug wire connection and clean, adjust, or replace the spark plug if faulty. If the issue persists, it might be dirt, water, or stale fuel in the fuel system, or a defective relay or switch, and you should contact an Authorized Service Dealer.
C
christopher13Aug 21, 2025
How to fix Exmark Turf Tracer TT20KCE Lawn Mower that pulls left or right?
- R
  Ricardo MendezAug 21, 2025
  If your Exmark Lawn Mower is pulling to the left or right, adjust the tracking by turning the knob on the right hydro control linkage in the direction needed, using 1/4 turn increments until it tracks correctly. Also, ensure the tire pressure in the drive tires is properly adjusted.
C
crystaltaylorAug 26, 2025
Why are the blades not rotating on my Exmark Turf Tracer TT20KCE?
- W
  wgriffithAug 26, 2025
  If the blades on your Exmark Lawn Mower aren't rotating, check the belt tension of the drive belt. Inspect the drive belt for damage and replace if necessary, ensuring it is correctly installed and the adjusting shafts and belt guides are properly positioned. Also, install a new deck belt if the current one is worn, loose, or broken. Install deck pulley and check the idler pulley, idler arm and spring for correct position and function. Replace the spring if the idler spring is broken or missing.
E
Emily ButlerAug 28, 2025
What causes uneven cutting height on my Exmark Turf Tracer TT20KCE Lawn Mower?
- A
  Ashlee JacksonAug 28, 2025
  To address uneven cutting height with your Exmark Lawn Mower, start by sharpening the blades. If any cutting blades are bent, replace them. Ensure the mower deck is level from side-to-side and front-to-rear. Clean the underside of the mower deck, and adjust the tire pressure in the drive tires. If the blade spindle is bent, or the tips of adjacent blades are at an uneven cutting height, contact an Authorized Service Dealer.
S
sperezAug 31, 2025
Why does my Exmark Turf Tracer TT20KCE Lawn Mower engine loses power?
- T
  Troy ThompsonAug 31, 2025
  If your Exmark Lawn Mower engine loses power, try reducing the ground speed, as the engine load may be excessive. Clean or replace the air cleaner element if it's dirty. Ensure the oil level in the crankcase is adequate by adding oil if it's low. Clear any obstructions from the cooling fins and air passages. Also, clean or replace the fuel cap if the vent hole is plugged, and replace the fuel filter if it's dirty. If the issue continues, there might be dirt, water, or stale fuel in the fuel system, and you should contact an Authorized Service Dealer.
M
Mark RamirezSep 4, 2025
What causes abnormal vibration in my Exmark Turf Tracer TT20KCE?
- C
  Christina HernandezSep 4, 2025
  If your Exmark Lawn Mower is vibrating abnormally, install new cutting blade(s) if the current one(s) are bent or unbalanced. Make sure to tighten the blade mounting bolt, engine mounting bolts, and any loose engine, idler, or blade pulleys. Install new belt if the current one is damaged. If the engine pulley or blade spindle is damaged, contact an Authorized Service Dealer.
C
Cindy MullinsSep 7, 2025
Why is my Exmark Turf Tracer TT20KCE Lawn Mower engine overheating?
- J
  Joe JohnsonSep 7, 2025
  If your Exmark Lawn Mower is overheating, reduce the ground speed to lessen the engine load. Also, ensure the oil level in the crankcase is sufficient by adding oil if needed.
V
Veronica VincentSep 12, 2025
What to do if my Exmark Lawn Mower machine does not drive?
- P
  pricebrandonSep 12, 2025
  If your Exmark Lawn Mower isn't driving, make sure the bypass valve is tightened securely. If that's not the issue, the drive or pump belt might be worn, loose, broken, or off a pulley, in which case you should change the belt.

Summary

Introduction

Safety

Safety Alert Symbol

Explains the meaning and use of the safety alert symbol for hazard identification.

Safe Operating Practices

Details recommended practices for safe and efficient mower operation.

Maintenance and Storage

Guidelines and precautions for performing maintenance and storing the mower.

Safety and Instructional Decals

Information on locating, maintaining, and understanding safety and instructional decals.

Operation

Slope Operation

Specific safety precautions and techniques for mowing on slopes.

Controls Overview

Description of the mower's main controls including OPC, drive levers, and more.

Drive Wheel Release Valves

Procedure for using drive wheel release valves to move the machine manually.

Tracking Adjustment Knob

Instructions for adjusting the tracking knob to ensure straight-line mower travel.

PTO Engagement Switch

Explanation of the PTO switch operation for engaging cutting blades.

Pre-Start Procedures

Steps to follow before starting the engine, including fuel and checks.

Operating Instructions

Step-by-step guide for starting, operating, and stopping the mower.

Starting the Engine

Detailed steps for starting the mower's engine under various conditions.

PTO Engagement and Disengagement

Procedure for engaging and disengaging the Power Take-Off (PTO) for blade operation.

Stopping the Engine

Steps for safely shutting down the mower's engine.

Driving the Machine

Instructions on how to drive the mower, including forward and reverse movement.

Drive Lever and Neutral Lock Latch Operation

Detailed operation of drive levers and neutral lock latches for control.

Driving in Reverse

Guidance on operating the mower in reverse, including turns and zero-turns.

Adjusting the Cutting Height

Procedure for setting the desired cutting height for the mower deck.

Adjusting the Anti-Scalp Rollers

Instructions for adjusting anti-scalp rollers for optimal deck performance.

Transporting a Unit

Safety precautions and procedures for transporting the mower.

Specifications

Model Numbers

Identifies the specific model numbers covered by this manual.

Engine Specifications

Details on the engine's type, RPM, and general specifications.

Fuel System Specifications

Information on fuel capacity, type, filter, and shut-off valve.

Electrical System Specifications

Data on charging system, battery, voltage, and fuses.

Safety Interlock System

Description of the safety interlock system features and operation.

Operator Controls

Overview of the steering control and drive system components.

Transmission Specifications

Details on the transmission type, pumps, motors, and oil.

Wheel Drive System

Information on the drive wheels, motors, and shafts.

Tires & Wheels

Specifications for tires, wheels, ply rating, and pressure.

Cutting Deck

Details on deck size, blade size, spindle type, and deck drive.

Dimensions

Measurements for overall width, length, height, tread, wheel base, and weight.

Product Overview

Torque Requirements

Specifications for torque values for various bolts and nuts during assembly or maintenance.

Maintenance

Recommended Maintenance Schedule

A comprehensive schedule outlining maintenance tasks based on service intervals.

Periodic Maintenance

Regular maintenance checks and tasks to be performed on the mower.

Engine Oil Level Check

Procedure for checking and maintaining the engine oil level.

Battery Charge Check

Instructions for checking the battery charge and charging requirements.

Mower Blade Inspection

Guidelines for inspecting and maintaining mower blades.

Safety Interlock System Check

Procedure for verifying the proper function of safety interlock systems.

Check for Loose Hardware

Instructions for inspecting and tightening loose hardware.

Service Air Cleaner

Procedure for servicing and replacing the air cleaner elements.

Engine Oil Change

Steps for changing the engine oil, including filter replacement.

Hydraulic Oil Level Check

Procedure for checking and topping off the hydraulic oil level.

Tire Pressure Check

Instructions for checking and adjusting tire pressures.

Belt Condition Check

Procedure for inspecting the condition of drive belts.

Lubricate Grease Fittings

Guidance on lubricating grease fittings at various points on the mower.

Lubricate Caster Wheel Hubs

Procedure for lubricating the caster wheel hubs.

Engine Shrouds and Cooling Fins Cleaning

Instructions for cleaning engine shrouds and cooling fins for optimal performance.

Spark Plug Check

Procedure for checking and maintaining spark plugs.

Fuel Filter Change

Instructions for replacing the fuel filter when necessary.

Hydraulic System Filter Change

Procedure for changing the hydraulic system filter.

Hydraulic System Air Purge

Steps for purging air from the hydraulic system.

Fuel Tank Mounting Hardware Specifications

Specifications for mounting hardware related to the fuel tank.

Thread Locking Adhesives

Information on the types of thread locking adhesives used on fasteners.

Adjustments

Deck Leveling

Instructions for adjusting the mower deck to ensure level cutting.

Belt Tension Adjustments

Information on adjusting belt tensions for drive and deck systems.

Brake Adjustment

Procedure for adjusting the mower's parking brake.

Speed Control and Neutral Safety Switch Adjustment

Adjustments for speed control linkage and neutral safety switch.

Neutral Control Linkages Adjustment

Procedure for adjusting neutral control linkages for proper drive wheel stopping.

Hydro Control Linkage Adjustment

Instructions for adjusting hydro control linkages for proper operation.

Drive Lever Linkage Adjustment

Procedure for adjusting the drive lever linkage for accurate control.

Tracking Adjustment

Instructions for adjusting the mower's tracking for straight-line movement.

Hydro Pump Spring Tension Setting

Guidance on adjusting hydro pump spring tension for different drive conditions.

Electric Clutch Adjustment

Information regarding the electric clutch adjustment (no adjustment needed).

Cleaning

Clean Grass Build-Up Under Deck

Instructions for cleaning grass and debris from under the mower deck.

Waste Disposal

Guidelines for the proper disposal of waste materials like oil.

Battery Disposal

Safety precautions and procedures for disposing of mower batteries.

Troubleshooting

Starter Does Not Crank

Troubleshooting steps for when the starter motor does not engage.

Engine Starting and Running Issues

Solutions for problems related to engine starting and continuous running.

Engine Power Loss

Diagnosis and corrective actions for reduced engine power.

Engine Overheating

Causes and remedies for engine overheating issues.

Tracking and Steering Issues

Troubleshooting for mower pulling left or right.

Machine Drive Issues

Solutions for problems related to the mower not driving.

Uneven Cutting Height

Diagnosing and correcting issues causing uneven cutting height.

Abnormal Vibration

Troubleshooting steps for excessive mower vibration.

Blade Rotation Issues

Solutions for problems where mower blades do not rotate.

Schematics

Electrical Diagram

Schematic showing the mower's electrical wiring and components.

Hydraulic Diagram

Schematic illustrating the mower's hydraulic system layout.

Exmark Commercial Turf Equipment 2 Year Limited Warranty

Warranty Coverage Details

Summary of what is covered, not covered, and warranty exceptions.

Obtaining Warranty Service

Instructions on how to initiate a warranty claim and find a service dealer.

Owners Responsibilities

Outlines the owner's duties for maintaining warranty validity.

General Warranty Conditions

General terms, limitations, and legal aspects of the warranty.

Mid-Mount Riding Accessories and Options

Out-Front Riding Accessories and Options

Walk-Behind Accessories and Options