Exmark TURF TRACER X-SERIES - Page 21

Operation
Figure7
LeftHandSideShown
AdjustingtheAnti-ScalpRollers
Itisrecommendedtochangetheanti-scalproller
position,whentheheightofcuthaschanged.
1.Stopthemachineandmovethemotioncontrol
leversoutwardtotheneutrallockedposition.
2.DisengagethePTO.
3.Engagetheparkbrake.
4.Stoptheengine,removethekeyandwaitforall
movingpartstostop.
5.Afteradjustingtheheightofcut,adjustthe
anti-scalprollersbyremovingthewhizlocknut
andspringdiscwasher.
6.Adjusttheanti-scalprollersforNormalOperating
Conditions.Placetherollersinoneofthe
positionsshown(
Figure8).Rollerswillmaintain
3/4inch(19mm)clearancetothegroundto
minimizegougingandrollerwearordamage.
Figure8
Forcuttingheightsabove3.5inches(90mm)usethe
bottomhole.Therollerswillstillbeeffectiveagainst
scalping.
1.Anti-scalproller
mountingbracket
2.Cuttingheight
ForMaximumDeckFlotation,placetherollers
oneholepositionlower.Rollersshouldmaintain
1/4inch(6.4mm)clearancetotheground.Do
Notadjusttherollerstosupportthedeck.
7.Besurethewhizlocknutsareinstalledwiththe
springdiscwasherbetweentheangeofthenut
andthemountingbracket.
8.Torquethe3/8–16whizlocknutto30-35ft-lb
(41-47N-m)(
Figure9).
9.Ifthe3/8nylocnuthasbeenremoved,reinstall
andtorqueto30–35ft-lb(41-47N-m).
Figure9
1.Springdiscwasher
(conetowardsnut)
3.3/8nyloc-torqueto30-35
ft-lb(41-47N-m)
2.Frontrightanti-scalp
bracketshown
4.3/8-16whizlocknut
torqueto30-35ft-lb
(41-47N-m)
21