EasyManua.ls Logo

EXMITTER EX7 User Manual

EXMITTER EX7
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
EXMITTER
-- Professional Remote Control Products Expert
Question and Answer IconNeed help?

Do you have a question about the EXMITTER EX7 and is the answer not in the manual?

EXMITTER EX7 Specifications

General IconGeneral
BrandEXMITTER
ModelEX7
CategoryRemote Control
LanguageEnglish

Summary

General Warnings and Safety

Safety Precautions

Essential safety rules for operating the RC transmitter and model, emphasizing careful use and maintenance.

Transmitter Layout and Controls

Transmitter Setup and Features

Install Batteries

Instructions for installing AA batteries into the transmitter's battery compartment.

One-Button ON/OFF Switch

Explains how to turn the transmitter on and off using the single button.

Low Voltage Alarm

Describes the alarm system that alerts the user when the transmitter battery voltage drops.

Retreatable Antenna

Details the feature of a retractable antenna for convenience during transport.

Receiver Installation and Binding

Receiver Connection & Binding

Steps for connecting the receiver and the process of binding it to the transmitter.

Failsafe Setting

How to configure the failsafe function for the receiver to maintain vehicle control on signal loss.

Menu Functions and Channel Settings

D/R Setting

Adjusting Dual Rate settings for channel travel volume based on preset positions.

Channel Reverse

Function to reverse the direction of any of the 7 available channels.

Advanced Control Adjustments

Endpoint Setting

Adjusting maximum travel volume for channels from -140% to 140%.

Sub-Trim

Adjusting the channel servo travel center point from -30% to +30%.

Trim and Mixing Functions

Digital Trims

Using digital trims to adjust servo output step-by-step.

Mixing Modes

Combining multiple channels to create new functional controls like DUALAILE, ELEVON, V-TAIL.

Model Management and Operations

Model Select

Managing and selecting from 6 available model memory slots for settings.

Multi-button Function Settings

Utilizing multi-button operations for advanced adjustments and settings.

Advanced Transmitter Operations

Potentiometer Calibration

Calibrating potentiometers for accurate stick input.

Turbo Switch

Activating or deactivating Turbo mode for increased transmission power.

Logo on/off

Toggling the display of the EXMITTER logo.

Mode1 / Mode 2 Switch

Switching between Mode 1 and Mode 2 for throttle and control stick configurations.

Mechanical Adjustments and System Features

Mode 1/2 Mechanical Switch Configuration

Instructions for physically switching the transmitter between Mode 1 and Mode 2.

FHSS Radio Control System

Overview of the Frequency Hopping Spread Spectrum system for enhanced stability.

Perform Range Check

Procedure for checking the operational range of the radio system before use.

Troubleshooting and Support

System Connection Issues

Solutions for when the transmitter and receiver are not communicating.

Receiver Response Problems

Troubleshooting steps for when the receiver fails to respond during operation.