Exor eTOP310 - 11 Command Summary

24
MANUGENETOP3xx - Version 2.00
© 2018 EXOR International S.p.A. - Subject to change without notice
The panels have an extended set of pre-dened commands. Commands are available for the use of the
built-in system functions including navigation in all system pages.
The chapter describes the touchscreen commands recognized by all panels. Commands are classied
according to the operating modes of the unit.
CLEAR
ENTER
Panels with touchscreen interface will show a touch keypad on the screen whenever operator input in
required. For System Commands the default keypad in shown in gure. All keypads, except the one shown
in Conguration Mode, can be changed by the programmer.
Touch screen panels will show automatically a numeric keypad whenever the data entry phase is acti-
vated. Pop-up keypads are congurable by users.
11 Command Summary

CAUTION
The standard command assignment is described in this chapter. All the commands, except those
dened for Conguration Mode, can be changed, deleted and/or extended using the Keyboard
Macro Editor facility of the programming software.
Note: The text ‘2 s’ associated to a key means that the key must be held pressed for two seconds to
activate the associated function.