To Next Page

To Previous Page

MANUGENEX7xx - Version 2.09

- The equipment shall only be used in an area of not more than pollution degree 2, as dened in IEC/EN 60664-1.

- The equipment shall be installed in an enclosure that provides a degree of protection not less than IP 54 in

accordance with IEC/EN 60079-15.

- Transient protection shall be provided that is set at a level not exceeding 140 % of the peak rated voltage

value at the supply terminals to the equipment.

- Install the HMI device according to the accompanying installation instructions.

- Ground the HMI device according to the accompanying installation instructions.

- Only qualied personnel may install the HMI device or repair it.

- Ensure that the aeration holes are not covered.

- Care shall be taken not to allow layers of dust to form on the graphic panel in a way that might cause the

accumulation of static charges. Keep the faceplate of the HMI device clean: the equipment must be clea-

ned only with a soft cloth and neutral soap product. Do not use solvents.

- This device should not be used for purposes and methods other than indicated in this document and

in the documentation accompanying the product.

eX Series 700 HMI products delivery conguration is based on a loader. Use the services of the loader to

install applications on the device such as JMobile runtime or browsers.

JMobile Studio version V2.6 or higher is required. JMo¬bile Studio is a software tool that must be properly

installed on a computer running Microsoft Windows.

There are two options to transfer a JMobile application project to a HMI device:

Ethernet Connect the HMI device to the computer with an Ethernet network. In JMobile Studio

select the command Run/Download to target. You may have to ensure that the proper

rewall policy has been congured in the computer to allow JMobile Studio to access

the network.

USB Create an Update Package using JMobile Studio and copy it to a USB Flash drive.

8 Special Instruction for Use

9 Getting Started

Exor eX715 User Manual

Questions and Answers: