Explore Scientific WSH4102 - Activating Alarm Function; Wireless Sensor Signal Receiving

22
adjust.
3. Press [ MODE / ALARM ] key again to step
the setting value to Minute with the Minute digit
ashing.
4. Press [ + ] or [ - ] key to adjust the value of the
ashing digit.
5. Press [ MODE / ALARM ] key to save and exit
the setting.
NOTE:
- In alarm mode, the “ ” icon will display on the
LCD.
- The alarm function will turn on automatically once
you set the alarm time.
ACTIVATING ALARM FUNCTION
1. In normal mode, press [ MODE / ALARM ] key to
show the alarm time for 5 seconds.
2. When the alarm time displays, press [ MODE /
ALARM ] key again to activate the alarm function.
Alarm off Alarm on
When clock reach the alarm time, alarm sound
will start.
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if
without any operation and the alarm will
activate again in the next day.
- By pressing [ALARM / SNOOZE] key to
enter snooze that the alarm will sound
again after 5 minutes.
- By pressing and hold [ALARM / SNOOZE]
key for 2 seconds to stop the alarm and
will activate again in the next day
- By pressing [ MODE / ALARM ] key to
stop the alarm and the alarm will activate
again in the next day.
NOTE:
- The snooze could be used continuously in
24 hours.
- During the snooze, the alarm icon “ ”
will keep ashing.
WIRELESS SENSOR SIGNAL RECEIVING
1. The console display signal strength
for the wireless sensor(s), as per table
below: