1. Loosen the drain
hose (A) and turn
the selector (B)
anticlockwise.
2. Loosen the
mixer bowl. Pull
straight out (C).
3. Loosen the
whisk (D) by
pulling it straight
out.
4. Loosen the
xing plate. Turn
the selector
anticlockwise (E)
until it stops.
5. Clean with a
moist cloth and
wipe dry.
6. Wash these
parts: Mixer bowl,
condensation trap,
whisk, xing plate.
7. Fit the xing plate
by turning the selector
clockwise. Check all
seals!
8. Ensure that the
plane side of the
whisk motor shaft
corresponds with
the plane side of the
whisk. See(G)
9. Ret by push-tting the
whisk until a click sound can
be heard (H).
10. Fit the mixer bowl
and the condensation
trap as per (J) See
image.
11. Push-t the mixer bowl as per (K) and x
with lever (L). Fit the drain hose (M).
(Attention! ensure that all water hoses have
been tted.)
Cleaning the mixer system
Important with cleaning!
It is important to clean some of the machine parts
regularly. This is important for the functioning of the
machine, for the quality of the drinks and to full the
requirements for cleanliness. Maintenance work must
be done with the power switched off. Cleaning must
be done every week. Sometimes even more often
depending on how often the machine is used. Neutral
detergents must be used (avoid detergents that may
harm colour or plastic). Never clean the machine by
spraying water directly at it.
Check all seals
Check all seals
To Previous Page
Loading...
Need help?
General
