14. Water Softener/filter Cleaning
a) Fill the water reservoir.
b) Dissolve 300 grams of table salt inside the water reservoir.
c) Insert the water softener filter inside the water reservoir.
d) Siphon the water reservoir through the water softener filter as indicated below.
Once the water reservoir is empty, fill it again with non-salt water and repeat the
process in order to clean the water softener filter.
ig. 9
15. Brewing Group & Coffee Filter Cleaning
a) Remove the filter holder from the machine.
b) Place the filter membrane on the coffee filter.
c) Insert special cleaning compound (available for commercial coffee companies) into the
filter holder according to manufacturers recommendations. Use only special detergent
for brewing group cleaning.
d) Place the filer holder in the brewing group and operate the star button for 5 seconds.
Repeat 5 times. For the Lever models: raise and lower for 5-second intervals. Repeat 5
times.
e) Clean the filter holder of cleaning compound by washing under the brew group and
repeat the process without compound. This will flush away any residue.
f) It will be necessary to soak the filter holder in the head-cleaning compound from time to
time to remove caked on coffee oils.
g) Once the cleaning cycle has finished, dismantle the filter holder and wash thoroughly.
.
DO NOT MANIPULATE THE FILTER HOLDER DURING THE CLEANING
CYCLE
It is recommended that you clean the brewing group once a week.
Filter membrane
To Next Page
Loading...
