41
USER PROGRAMMING - ONYX
Setting the time and day
Setting the Auto On/Off times
Use the following steps to set the time and day displayed by the machine:
1. Enter the dose programming menu. The display will show Doses Programming.
2. Long press the Continuous Dispensing button again for two seconds until the display shows
Clock Adjust.
3. Press the 2 Short Espressos button to access the time and day settings.
4. To adjust the hours, minutes and day of the week use the 1 Short Espresso and 1 Long Espresso
buttons to scroll the ashing eld up or down.
5. When the ashing eld is set to the desired input press the 2 Short Espressos button to proceed
to the next eld.
6. When all elds are set as desired, press the Continuous Dispensing button to proceed to the
next programmable input, Auto ON/OFF, or continue pressing it until the user programming
menu is exited.
Use the following steps to set the automatic power on and heat up/power down and cool off times for
each day used the machine:
1. Enter the dose programming menu. The display will show Doses Programming.
2. Long press the Continuous Dispensing button again for two seconds until the display shows
Clock Adjust.
3. Press the 2 Short Espressos button several times to proceed to the Auto On/Off setting. The
currently programmed setting will be displayed, use the 1 Short Espresso and 1 Long Espresso
buttons to scroll the ashing eld up or down.
4. To adjust the Auto On settings use the 1 Short Espresso and 1 Long Espresso buttons to scroll
the ashing eld up or down.
5. When the ashing eld is set to the desired input press the 2 Short Espressos button to proceed
to the next eld. Repeat this step for each day’s Auto On and Auto Off times.
6. When all elds are set as desired, press the Continuous Dispensing button to proceed to the
next programmable input - Counters - or continue pressing it until the user programming menu
is exited.
Note:
The user programming menu is only accessed via the left-side brewer bank’s buttons.
i
Note:
For any day(s) of the week that the machine will not be routinely used, simply program the Auto
On/Off setting time as --.-- and the machine will interpret it as disabled for that day.
Pro Tip:
The Auto On/Off function is useful for programming the machine to be warmed up and ready
before the rst barista arrives at the start of each day, and saves a lot of energy by making sure
the machine shuts down automatically at the end of each day even if the main switch is still
turned on.
i
To Next Page
Loading...
Need help?
General
