What to do if my Expobar Coffee Maker does not start up?
If your Expobar Coffee Maker doesn't start, there are a few things to check. First, make sure the plug is fully inserted into the power socket and that the socket is working. Also, verify that the circuit breaker and/or differential are connected. If the cable or plug is damaged, it will need to be replaced by qualified service personnel.
Why is coffee dispensing very slow in my Expobar ROSETTA MINI CONTROL 1GR Coffee Maker?
If the coffee dispensing from your Expobar Coffee Maker is very slow, the coffee grinding might be too fine. Try adjusting the coffee-grinding setting to a coarser grind.
Why is coffee dispensing very fast from my Expobar Coffee Maker?
If the coffee dispensing from your Expobar Coffee Maker is very fast, it may be due to the coffee grinding being too coarse. Adjust the coffee-grinding setting to a finer grind.
How to fix an Expobar ROSETTA MINI CONTROL 1GR steam wand that does not dispense steam?
If the steam wand on your Expobar Coffee Maker isn't dispensing steam, it's likely clogged with milk. Clean the wand thoroughly. If the clog persists, remove the nozzle and use a pin or needle to carefully unclog it.
What to do if water is found underneath my Expobar ROSETTA MINI CONTROL 1GR Coffee Maker?
If you find water underneath your Expobar Coffee Maker, the drainage tube is probably blocked. You should clean the drainage tube to resolve this issue.
General| Brand | Expobar |
|---|---|
| Model | ROSETTA MINI CONTROL 1GR |
| Category | Coffee Maker |
| Language | English |
To Next Page