Expobar ROSETTA MINI CONTROL 1GR - Messages and ALARMS

32
R
ROSETTA
MESSAgES AND ALARMS
Fault in flow meter X
Flow fault detected in counter X
Flowmeter
Gr. X
Check that the machine is receiving water.
Time-out alarm
Boiler filling up
Temperature sensor fault
Probe unconnect
Service the machine.
To disable the alarm and reset the counter:
Turn off the machine. Simultaneously press and hold down the
1 short espresso
and 1 Long Espresso buttons.
Turn on the machine.
Service
999999999
Regenerate the filter.
To disable the alarm and reset the counter:
Turn off the machine. Simultaneously press and hold down the
2 Short Espressos
and 2 Long Espressos buttons.
Turn on the machine.
Change filter
999999999
If boiler lling time exceeds the programmed time (2 minutes), all of the drink buttons lights will ash and
the machine will be disabled. To re-enable it, turn the machine off and on again at the power switch.
If the electronic control panel does not receive a pulse from the ow meter (coffee too ne or ow meter
fault) within 5 seconds of pressing one of the espresso buttons, the light for the dose selected will start to
ash. To disable it, press the dose button again.
As an additional safety, all dose settings have a maximum dispensing time of 5 minutes.