EasyManuals Logo

Expobar ROSETTA MINI CONTROL 1GR User Manual

Expobar ROSETTA MINI CONTROL 1GR
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
25
R
ROSETTA
CLEANINg AND MAINTENANCE
Cleaning the gasket and shower plate
WARNING!
Take special care to avoid scalding when
performing this cleaning operation, as the
hot water used to clean the gasket will
spill over the sides of the porta-lter.
WARNING!
Do not fully tighten the porta-lter. If fully
tightened, high-pressure water may spray
out and cause scalding or serious injury.
When placing the porta-lter lled with grinded coffee into the brewing group, left overs will accumulate in the
closing surface. If these remains are excessive it can prevent a good closing between the porta-lter and the
group head.Moreover, these remains can even block the dispensing of water through the group head.
To prevent this perform the following cleaning:
Place the cleaning membrane in the lter basket (without detergent).
Insert the porta-lter in the group head, but do not tighten fully (the porta-lter should be loose).
Press the Continuous Dispensing button on the button panel.
Make an opening-closing movement of the porta-lter in place without closing it. Water will now ow
around the porta-lter, owing through the closing surface and cleaning it.
Cleaning the gasket
Cleaning the shower plate
Remove the porta-lter from the group head.
Clean the shower and gasket with a soft brush to remove any coffee remains.
Shower
plate
Leftover coffee
requiring
cleaning

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Expobar ROSETTA MINI CONTROL 1GR and is the answer not in the manual?

Expobar ROSETTA MINI CONTROL 1GR Specifications

General IconGeneral
BrandExpobar
ModelROSETTA MINI CONTROL 1GR
CategoryCoffee Maker
LanguageEnglish

Related product manuals