Extech Instruments EC210 User Manual

EC210-en-GB_V1.1 11/14
6
Setupmode
Note:IftheHOLDorMIN/MAXfunctionsareactivetheSetupmodecannotbeaccessed.

ToentertheSetupModepressandholdtheSETTINGbuttonforatleast5seconds(untilthebeep
isheard)andthenusetheSETTINGbuttontoscrollthroughthesetupoptions.Theoptionsare:
 SEtAutomatictemperaturecompensationpercentage;settablefrom0.00to5.00%per°C
(thedefault
is2.00%).Setto0.00%totakeuncompensatedConductivitymeasurements.
Whenpoweriscycledthisparameterwillreverttothedefault2.00%
 °C/FSelectthetemperatureunits(°C°F)
 OFF/ONAutopoweroffdisable/enable

Continuewiththeinstructionsbelow:

TemperatureCompensationPercentSetting(SEt)
Whenthedisplay
showsSEtpressENTER.SEtwillflashand theupperdisplaywillshowthe
temperaturecompensationpercent.Usethe▲ and ▼ buttonstosetthedesired
temperaturecompensationpercentage.Afterselectingthedesiredvalue,pressENTERto
savethedata.Thedisplaynowshowsthetemperatureunits.Continuebelow:
Temperature
UnitsSelect
ThelowerdisplayshowsCorF.Usethe▲buttontoselectthedesiredunitofmeasureand
thenpressENTERtosave.ThelowerdisplayshouldnowshowOFFYESorNO.Continue
below:
AutoPowerOFFEnable/Disable
ThedisplaywillshowOFFYESor
OFFNO.Usethe▲buttontoselectYESorNO.
YES:AutopowerOFFisenabled(meterswitchesoffautomaticallyafter10minutes)
NO:AutopowerOFFisdisabled
PressENTERtosavetheselection.Themeterwillreturntothenormaloperatingmode.


Extech Instruments EC210 Specifications

General

Brand	Extech Instruments
Model	EC210
Category	Measuring Instruments
Language	English