20
3.5 Threading of Polypropylene Strap
3.5.1 Strap Specification
Material: Polypropylene Strap
Width: 5-15.5mm only adjustment
Thickness: 0.45mm-0.7mm (any strap outside this range, please contact EXTEND for
further studying)
Core diameter: 200mm (230mm and 280mm as option)
Core width: 190mm-200mm
Strap with excessive chamber (5mm with 200cm length) cannot be used.
3.5.2 Strap Coil Installation
How to Load and Thread P.P. Strap
The threading procedure involves routing strap from the dispenser and up through
the strapping head.
a. Rotate nut handle (A) counter clockwise to remove from dispenser unit, take off
the dispenser flange and remove old strap coil inside.
b. Remove all adhesive strips or other adhesive material from new strap coil
c. Follow the rotation direction sticker on dispenser, to put the new strap coil onto
dispenser unit
d. Put the outer dispenser flange back on and tighten reel nut handle (A) in
clockwise.
e. Unroll about 0.5 m of strap and make sure that it is not twisted.
f. Thread the strap through the guide roller bracket (B) and the loop (C).
g. Insert strap upward into machine, until the strap hits something, then please
hold the strap
h. Press the feed button to feed the strap.
To Next Page
Loading...
