47
If you go beyond this parameter unintentionally, exit by pressing button 1 and repeat the
procedure.
The value “00” will be shown on D1: using buttons 2 and 3, you can set an increased/decreased
percentage at 5 point intervals (the parameter can be modified with a maximum scale from -50 to
+50).
Adjustment table
LACK OF
PELLETS
further 5 percent. Repeat this process until the problem is resolved.
If the problem cannot be resolved, contact the service centre.
When the final adjustment has been made, press button 1 to confirm and exit the program.
15.4 Heat distribution motor parameters
These parameters enable you to carry out some operations regarding the heat distribution motor
of the Divina Plus stove.
To access these parameters, press button 3 and hold it down, then press button 5. Move through
the menu by pressing button 5 until a blinking “G” appears on D2.
Parameter Table
off G Distribution motor start/stop
00 H % setting of distribution motor
The parameter “G” is for enabling/disenabling operation of the distribution motor. Simply use
buttons 2 and 3 on D1 to set “on” to enable or “off” to disenable the motor. To confirm and exit,
press button 1. To continue with programming, press button 5.
The parameter “H” enables you to make a percentage modification (therefore proportional on all
the power levels) of the speed of the distribution motor on the Divina Plus model.
Display D1 will show “00”: using buttons 2 and 3, you can increase/decrease the value at 5 point
intervals (the parameter can be modified with a maximum scale from -50 to +30). When the final
adjustment has been made, press button 1 or 5 to confirm and exit.
To Next Page
Loading...
Need help?
General
