Extreme Networks ExtremeCloud Appliance Series - Page 188

Static Routes
Use static routes to set the default route of the ExtremeCloud Appliance so that device trac can be
forwarded to the default gateway. To add a static route, click Add.
Related Links
Add an Interface on page 188
Add a Static Route on page 189
Add an Interface
You must be a system administrator to add a network interface. Take the following steps:
1 Go to Administration > System.
2 Under Interfaces click Add.
The Create New Interface dialog displays.
3 Configure the following parameters:
Table 76: Interface Parameters
Field Description
Name Name of the interface.
Mode Describes how trac is forwarded on the interface topology.
Options are:
•
Physical - The topology is the native topology of a data plane
and it represents the actual Ethernet ports.
•
Management - The native topology of the ExtremeCloud
Appliance management port.
VLAN ID ID for the virtual network.
Tagged Indicates if the interface tags trac. When trac is tagged, the
VLAN ID is inserted into the packet header to identify which VLAN
the packet belongs to. Tagging can identify the port or interface to
send a broadcast message to.
Port Physical port on the ExtremeCloud Appliance appliance for the
interface.
Enable Device Registration Enable or disable AP registration through this interface. When
enabled, wireless APs use this port for discovery and registration.
Other ExtremeCloud Appliances can use this port to enable inter-
ExtremeCloud Appliance device mobility if this port is configured to
use SLP or the ExtremeCloud Appliance is running as a manager
and SLP is the discovery protocol used by the agents.
Management Trac Enable or disable Management Trac through this interface.
Enabling management provides access to SNMP (v1/v2c, v3), SSH,
and HTTPs management interfaces.
MTU Maximum Transmission Unit (MTU). Standard is 1500 bytes. Fixed
value.
Layer 3
Administration
ExtremeCloud Appliance User Guide for version 4.36.03 188