Px Series Application Switch Installation and Configuration Guide 10-7
Managing and Troubleshooting Operation
Managing and Troubleshooting Operation
Table 10-5 lists the commands that are used to display management and troubleshooting
information.
flg The configured flags for the server or service.
■ E = checks enabled
■ D = down
■ U = up
■ R = MAC address of server is resolved
■ N = MAC address of server is not resolved
■ F = forced down
curr-cons The current number of connections for the server. Not shown for virtual
services.
max-connections The configured maximum number of connections for the server. Not
shown for virtual services.
run When positive, the number of consecutive check passes, up to the
restore-after value.
When negative, the number of consecutive check failures, up to the
fail-after value.
ra The configured restore-after value.
fa The configured fail-after value.
Table 10-5: Management and Troubleshooting Commands
Command Description
show errors Displays any system-level errors that have been detected.
show syslog Displays the contents of the system log.
Table 10-4: show server details Information
Column Description
To Next Page
Loading...
