Extreme Networks Px Series - Configuring a Default Gateway

8-8 Px Series Application Switch Installation and Configuration Guide
# configure ESRP, with additional VLANs under master VLAN
config esrp port-mode host ports 1
config esrp port-mode host ports 8
config vlan "master" add domain-member v2
config vlan "master" add domain-member v3
enable esrp vlan master
Configuring a Default Gateway
The Px series application switch supports two gateways. If the primary default gateway
(router) fails, the application switch will change to a second gateway
• To add a default gateway use the following command:
config default-gateway add <ip>
• To delete a default gateway use the following command:
config default-gateway delete <ip>
• To switch between default gateways use the following command:
config default-gateway switch