Extreme Networks Px Series - Example Configuration

4-18 Px Series Application Switch Installation and Configuration Guide
To start and stop the GlobalPx Content Director agent on the Px series application
switch, use the following commands:
enable gslb-agent [port <number>]
disable gslb-agent
To check on the agent’s activities, use the following command:
show gslb-agent
gslb-agent is [enabled | disabled]
listening on IP address a.b.c.d:port
last contacted by scheduler ipaddr at time
contacted by schedulers: ipaddr ipaddr ipaddr …
current load: <num>
For more information, see the GlobalPx Content Director Installation and User Guide.
Example Configuration
In the following example, a Px series application switch is installed in a site with a
syslog server and network manager on a back end management network, and a DNS
server on the main network.
WS_015
DNS server
64.1.1.9
Internet
Syslog server
10.10.10.20
SummitPx1
system IP 64.1.1.10
proxy IP 64.1.1.11-24
Layer 3 switch
64.1.1.1
Net manager
10.10.10.21
Management IP
64.1.1.10
Management net
10.10.10.1