Extreme Networks Px Series - Page 49

Px Series Application Switch Installation and Configuration Guide 4-19
Example Configuration
The following commands configure all system-related facilities:
#----------------------------------------------------------------
# system configuration
#----------------------------------------------------------------
config system-ip 64.1.1.10 / 24
config default-gateway 64.1.1.1
disable vlan
config mgmt ipaddress 10.10.10.10 / 24
enable syslog
config syslog ip 10.10.10.20
config nat-mode full
enable clipaging
disable port gigabit
#----------------------------------------------------------------
# proxy-ip's
#----------------------------------------------------------------
config proxy-ip 64.1.1.11 - 64.1.1.42
#----------------------------------------------------------------
# SNMP configuration
#----------------------------------------------------------------
config snmp sysName “balancer”
config snmp sysLocation “Exodus Colo”
config snmp sysContact “Web Admin”
config add trap receiver 10.10.10.21 “public” 162
config snmp add community readonly “readme”
config snmp add community readwrite “doall”