Table 3: List of Execution Modes (continued)
Mode Access Level Prompt
VLAN (Virtual LAN) Interface Config Mode Engineer
(vlan-intf-conf)#
IGMP (Internet Group Management Protocol)
MVR Profile Config Mode
Engineer
(igmp-mvr-profile-conf)#
IGMP ACL Profile Config Mode Engineer
(igmp-acl-profile-conf)#
RingV2 Group Config Mode Engineer
(ring)#
Trunk Group Config Mode Engineer
(trunk-group-conf)#
Using the CLI Help
You can get help by entering a question mark (?) at each position in the command. The displayed result
depends on the execution mode and previous input.
Terminal Key Function
Following is the list of all the terminal keys and their function.
Table 4: List of Terminal Keys
[ENTER]
Run a CLI config script
[CTRL] + [M]
[TAB] Tab completion.
If [TAB] is pressed after a non-whitespace character, complete the word before the
Tab.
If [TAB] is pressed after a whitespace character, complete the next word.
[CTRL] +[I]
[?]
Display available commands.
If ? is pressed after a non-whitespace character, show possible choices for this
word.
If ? is pressed after a whitespace character, show possible choices for the next word.
up arrow
Up history
[CTRL] + [P]
down arrow
Down history
[CTRL] + [N]
[Home]
Move the cursor to the beginning of the input line
[CTRL] + [A]
[End]
Move the cursor to the end of the input line
[CTRL] + [E]
left arrow
Move the cursor backward
[CTRL] + [B]
right arrow Move the cursor forward
Getting Started with the ISW Switch
ISW Series Managed Industrial Ethernet Switch Command Reference Guide 9
To Next Page
Loading...
Need help?
General