EasyManuals Logo

Ezviz BC1C User Manual

Ezviz BC1C
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
6
4. Intelligent Human Detection
Go to Settings - Intelligent Human Detection and enable it. Then EZVIZ will send
you notifications when a trigger is detected.
To let the camera respond differently in different situations, you can customize
the detection notification by changing settings of detection sensitivity. The
higher sensitivity is, the further distance can be detected.
5. Active Defense
With intelligent human detection enabled, the camera will automatically trigger
alarm and start recording once human or animal is detected. Alarm stops until
no motion is detected.
In addition, you can also tap the Active Defense button on the device page to
trigger an alarm. The camera will sound an alarm and the spotlight will flash
quickly to deter intruders, which can last up to one minute.
FAQ
Q: If the camera is offline on the App, will the video recording be continued?
A: If the camera is powered on but disconnect to the Internet, then local
recording will continue but cloud recording will stop. If the camera is powered
off, both video recordings will stop.
Q: Why the alarm is triggered when nobody in the image?
A: Try to set the alarm sensitivity lower. Please notice that vehicle and animals
are also the trigger source.
Q: Does the camera support adding an SD card?
A: The camera has a built-in 32G eMMC memory card, loop recording, and does
not support SD card capacity expansion.
Q: Why is the memory card capacity less than 32G displayed on the App?
A: Due to the calculation difference between binary and decimal arithmetic, the
memory card's actual capacity is about 90% of the standard capacity.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ezviz BC1C and is the answer not in the manual?

Ezviz BC1C Specifications

General IconGeneral
Mounting kitYes
Number of cameras1
TypeIP security camera
Operating frequency2400 - 2483.5 MHz
Placement supportedOutdoor
Connectivity technologyWireless
Built-in HDDNo
Flash memory32768 MB
Sustainability certificatesCE, Federal Communications Commission (FCC), REACH, RoHS, UL ECOLOGO, WEEE
Form factorBullet
Mounting typeCeiling/wall
Product colorBlack, Grey
Protection featuresDust resistant, Water resistant
International Protection (IP) codeIP66
Security algorithms64-bit WEP, 128-bit WEP, WPA, WPA-PSK, WPA2, WPA2-PSK
Minimum illumination0.2 lx
Adjustment shutter speedAuto
Sensor typeCMOS
Optical sensor size1/2.8 \
Battery capacity7800 mAh
DC output current2 A
DC output voltage5
Power source typeBattery
Battery technologyLithium
Operating temperature (T-T)-20 - 50 °C
Operating relative humidity (H-H)0 - 95 %
Fixed focal length2.8 mm
LED typeIR
Night vision distance10 m
Total megapixels2 MP
Maximum resolution1920 x 1080 pixels
Supported video modes1080p
Video compression formatsH.264, H.265
Noise reduction technology3D noise reduction
Supported graphics resolutions1920 x 1080 (HD 1080)
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Networking standardsIEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Wi-Fi data rate (max)72 Mbit/s
Weight and Dimensions IconWeight and Dimensions
Depth62.8 mm
Width104.76 mm
Weight365 g

Related product manuals