4
Installation
1� Installation Location
Choose a location with a clear, unblocked field of view and with a good wireless signal to the camera. Please keep the
following tips in mind:
• Make sure the wall is strong enough to withstand three times the weight of the camera.
• Recommended installation height: 6 ft (1.8 m) above the ground.
• Recommended installation angle: Tilt down 15 degrees.
Do not install outdoors
Do not install the camera
under strong light conditions
Do not install at the place
with blocked eld of view
Do not place the camera
near any outlets
Important Notes on Reducing False Alarms:
• Do not install the camera under strong light conditions, including sunshine, bright lamp lights, etc.
• Do not place the camera near any outlets, including the air conditioner vents, humidier outlets, the heat transfer vents of projectors, etc
• Do not install the camera at places with strong wind.
• Do not install the camera in front of a mirror.
• Keep the camera at least 1 meter away from any wireless devices, including Wi-Fi routers and phones in order to avoid wireless
interference.
• It is recommended to set detection sensitivity on EZVIZ app when selecting location. Thus you can verify if motion can be
detected in the camera’s placement and adjust the sensitivity based on the size and distance of detected object.
2� Installation Steps
1� Install Micro SD Card (Optional)
- Insert the Micro SD card (sold separately) into the card slot as shown in the gure below.
After installing the Micro SD card, you should initialize the card in the EZVIZ app before using it.
- In the EZVIZ app, tap the Storage Status in the Device Settings interface to check the SD card status.
- If the memory card status displays as Uninitialized, tap to initialize it.
The status will then change to Normal and it can store videos.
To Next Page
Loading...
Need help?
General
