What to do if FAAC Control Panel gate opens but does not close?
If your FAAC Control Panel gate opens but doesn't close, first ensure that you have selected the desired operating mode. Also, one of your reversing devices might be preventing the gate from responding to your signal. Verify that the reversing devices are working properly. The LED DL2 should be illuminated; if it's not, check the devices.
Why FAAC Control Panel gate doesn't open or close though the motors are running?
If your FAAC Control Panel gate motors are running but the gate isn't opening or closing, make sure that the motor is running in the right direction. Also, ensure that the Manual Release mechanism has fully engaged the worm screw drive.
How to fix FAAC Control Panel gate that does not fully open or close?
If your FAAC Control Panel gate isn't fully opening or closing, try reprogramming the control panel. Also, check for any obstructions in the gate's path or ensure that the hinges are not binding.
Why FAAC Control Panel gate does not respond to the activating signal?
If your FAAC Control Panel gate isn't responding to the activating signal, there could be several reasons. First, ensure that you have correctly wired both the operator and the activating device to the control panel. Check fuse F2 (for the motor[s] of the operator[s]) and F1 (for accessories such as activating devices), and replace any blown fuses. Also, verify that your activating device functions correctly by using an ohm meter to confirm that the contacts are open normally and close when you activate the device. Finally, examine LED DL3; it should be illuminated if the stop device isn't preventing the gate's operation.
What to do if FAAC Control Panel radio controlled opener does not open the gate?
If the radio controlled opener for your FAAC Control Panel gate isn't working, start by checking the light on the remote transmitter. It should illuminate when you send a signal to the gate. If it doesn't light up, and the batteries are fine, you may need to repair or replace the transmitter. Also, make sure that the radio receiver is properly plugged in and that the LED on the receiver illuminates when a signal is sent.
Why FAAC Control Panel operator doesn't work smoothly and the gate jerks as it opens and closes?
If the FAAC Control Panel operator isn't working smoothly and the gate jerks, ensure that the Manual Release mechanism has fully engaged the worm screw operation of the operator. If the gate leaf flexes, stiffen the gate or use a slower operator.
General| Operating Temperature | -20°C to +55°C |
|---|---|
| Protection Class | IP44 |
| Thrust | 3500 N |
| Cycles per hour | 18 |
| Type | Electromechanical |
| Power Supply | 230V AC |
| Opening time | 18 seconds (to 90°) |
| Motor Voltage | 230V |
To Next Page
