FAAC 422 - Installing the Rear Bracket; Steel Pillar; Masonry Pillar with Plate to Embed; Masonry Pillar with Screw-On Plate

11
12
14
13
15
422 13 732870 - Rev.C
Translation of the original instructions
ENGLISH
Translation of the original instructions
ENGLISH
5.2 INSTALLING THE REAR BRACKET
RISKS
PERSONAL PROTECTIVE EQUIPMENT
!
The structure of the pillar must be suitable for fixing the actuator. If neces-
sary, create a solid support to which to attach it. It is the responsibility of
the installer to provide suitable fastenings for the applied loads. Welding
must be carried out in a workmanlike manner. Safety may be affected if it
is carried out badly.
Li
Keep to the measurements indicated. If necessary, modify the length of
the rear bracket arm.
STEEL PILLAR
Weld the rear bracket arm to the pillar (11).
MASONRY PILLAR WITH PLATE TO EMBED
- Embed the plate into the pillar (12).
- Weld the rear bracket arm (13).
MASONRY PILLAR WITH SCREW-ON PLATE
- Drill holes in the pillar and install the rear bracket plate (14).
Use dowels with suitable screws and fastening torque.
- Weld the rear bracket arm onto the plate (15)