FAAC E024 U - Page 13

13
present) starts moving slowly. The LED will blink
during all the setup procedure
2. The leaf 2 will move in closing direction until it
reaches the mechanical stop or FCC2
3. The leaf 1 starts moving slowly until it reaches the
mechanical stop or FCC1
4. The leaf 1 starts moving in opening direction at the
set speed (trimmer speed).
5. At the point where you want the slowdown to start
give an OPEN A command with the push button or
the remote that is already stored in memory. The
leaf 1 starts to slow down and stops when it reaches
the mechanical stop or FCA1.
6. The leaf 2 starts moving in opening direction at the
set speed (trimmer speed)
7. At the point where you want the slowdown to start
give an OPEN A command with the push button or
the remote that is already stored in memory. The
leaf 2 starts to slow down and stops when it reaches
the mechanical stop or FCA2.
8. The leaf 2 starts to close at the set speed (trimmer
speed).
9. At the point where you want the slowdown to start
give an OPEN A command with the push button or
the remote that is already stored in memory. The
leaf 2 starts to slow down and stops when it reaches
the mechanical stop or FCC2.
10. The leaf 1 starts to close at the set speed (trimmer
speed).
11. At the point where you want the slowdown to start
give an OPEN A command with the push button or
the remote that is already stored in memory. The
leaf 1 starts to slow down and stops when it reaches
the mechanical stop or FCC1.
12. 12. The manual time learning procedure is com-
plete.