1
ENGLISH
WARNINGS
• Important! For the safety of people, it is important that all the instructions be carefully observed.
• Incorrect installation or incorrect use of the product could cause serious harm to people.
• Carefully read the instructions before beginning to install the product and keep them for future
reference.
• The symbol
indicates notes that are important for the safety of persons and for the good condition
of the automated system.
• The symbol
draws your attention to the notes on the characteristics and operation of the
product.
CE DECLARATION OF CONFORMITY
Manufacturer: FAAC S.p.A.
Address: Via Benini, 1 - 40069 Zola Predosa BOLOGNA - ITALY
Declares that: Control board mod. E024,
• conforms to the essential safety requirements of the following EEC directives:
73/23/EEC and subsequent amendment 93/68/EEC.
89/336/EEC and subsequent amendment 92/31/EEC and 93/68/EEC
Additional information:
This product underwent a test in a typical, uniform configuration.
(all products made by FAAC S.p.A)
Bologna 01-06-2007. The Managing Director
A. Bassi
INDEX
1 WARNINGS ....................................................................................................................2
2 LAYOUT AND CONNECTIONS .........................................................................................2
3 TECHNICAL SPECIFICATIONS ........................................................................................3
3.1 DESCRIPTION OF COMPONENTS ...........................................................................................3
3.2 DESCRIPTION OF TERMINAL-BOARDS ....................................................................................3
4 PROGRAMMING THE LOGIC ..........................................................................................3
5 PROGRAMMING THE SPEED ...........................................................................................3
6. START-UP ........................................................................................................................4
6.1 LEDS CHECK ........................................................................................................................4
6.2 PROGRAMMING THE DIPS-SWITCH ........................................................................................4
6.3 PRE-FLASHING ....................................................................................................................4
6.4 TIME - SETUP LEARNING ....................................................................................................... 4
6.4.1 AUTOMATIC SET-UP ........................................................................................................................4
6.4.2 MANUAL SET-UP .............................................................................................................................4
7 INSTALLATION OF BUS ACCESSORIES .............................................................................5
7.1 ADDRESSING THE BUS PHOTOCELLS ..................................................................................... 5
7.2 MEMORY STORAGE OF BUS ACCESSORIES.......................................................................... 6
8 MEMORY STORING THE RADIO CODE ............................................................................6
8.1 MEMORY STORAGE OF DS RADIO CONTROLS ...................................................................... 6
8.2 MEMORY STORAGE OF SLH RADIO CONTROLS .................................................................... 6
8.3 MEMORY STORAGE OF LC RADIO CONTROLS (for some markets only) .............................7
8.3.1 REMOTE MEMORY STORAGE OF LC RADIO CONTROLS ................................................................. 7
8.4 RADIO CONTROLS DELETION PROCEDURE ........................................................................... 7
9 CONNECTION OF BUFFER BATTERIES (OPTIONAL) ...........................................................7
10 AUTOMATED SYSTEM TEST..............................................................................................7
11 LOGIC TABLES ...............................................................................................................8
To Next Page
Need help?
General
