TX 7 532402web - Rev.A
4
3
» = 20 S» = 2 S
» = 20 S
Fig.3
After flashing for 20 seconds from the last memorisation process, the LED switches off to
indicate that the procedure has ended.
Whenever a code is memorised, the
receiver/electronic equipment LED lights
up steadily for 2 seconds and then flashes
for 20 seconds, during which the user can
memorise the new code.
If the
LED
is not steady and
continues to flash for 20
seconds, it means that the
memory is full.
If the memorisation was completed
successfully, the LED flashes green and red.
To Next Page
Loading...