FAAC XT2-XT4 FDS 433-868 - Cloning FDS Transmitters

TX 8 532402web - Rev.A
≤ 5 cm
2
4
1
3
Fig.4
While the LED is still flashing, bring the new transmitter you want to
register to a distance of less than 5 cm from it and keep one in front of the
other.
Press the button (P...) on the new transmitter, on which you wish to memorise the code.
Press the button (P...) of the transmitter that has already been memorised for 10 sec. until the
LED flashes quickly red/green in sequence and then release it. The LED flashes for 20 secs.
If it was memorised successfully, the LED of the new transmitter flashes green and red.
3.2 MEMORISING OTHER FDS TRANSMITTERS
ALREADY MEMORISED
ALREADY MEMORISED NEW