FAAC XT2-XT4 FDS 433-868 - FDS Mode Operations Guide; Memorizing FDS Transmitters

TX 6 532402web - Rev.A
2
1
» = 20 S
Fig.2
3. FDS MODE
The procedures described below are valid for both the basic version FDS and the two-way version
FDS BD (the two-way version vibrates to confirm that an operation has been performed).
3.1 MEMORISING THE TRANSMITTER
Refer to the receiver or the electronic equipment instructions to identify the buttons and LEDs
described below.
Carry out the memorisation procedure keeping the transmitter about 50 cm away from the receiver.
Press and release the learning button on the receiver/electronic equipment.
The LED flashes slowly for 20 seconds.
Press and release the button to be memorised within 5 seconds.
5 s