Facina VKPCCTV - PIR Timeout and Time Lapse Mode Setup; Setting Time Lapse Mode (TLS)

Facina_VKPCCTV_Instructions_Rev01
20
setting or pressing and hold [M] button 2 seconds to exit.
Setting the Time Out in PIR mode:
Your camera can set the amount of time in seconds or minutes
the camera will sleep between two PIR triggers.
• In order to complete the Burst Shoot or Time of Video
Length settings, press [M] button.
• The status display will show out CAM T-O or VIDEO T-O in
blinking
• Press [M] button to into the Time Out setting.
• Press [UP] or [DN] button to increase or decrease the first
digit of minutes, then [M] to confirm and go to next digit
of minutes, repeat by pressing [UP] or [DN] then [M] to
complete minutes and seconds value, and then save the
time out setting.
• You’ll then see the word PIR blinking. Press [DN] button
twice to SET menu or press and hold [M] button 2
seconds to exit and camera stays at PIR detection mode.
Setting the Time Lapse Mode (TLS):
The Time Lapse default setting value is from 19:00 to 07:00 next
day. When the camera is set to use the Time Lapse Mode (TLS),
the program settings will follow the Time Lapse settings, and if
PIR is active during the TLS, the time out of TLS will resume.
Outside of the Time Lapse time frame; the camera will follow
the user defined PIR settings.
Your camera can be set operative for a pre-determined time
period [such as 19:00 to 07:00]. And then sets the frequency of