Facina_VKPCCTV_Instructions_Rev01
30
Using the Camera in Time Lapse Mode
• Mount the camera to the tree or wall or other sturdy
object using the supplied mounting strap.
• Open the cover and slide the switch to TEST position.
• Press [M] button once to call out the program menu and
the word PIR or TLS will be blinking.
• Press [DN] button until you see the word TLS blinking.
• Press [M] button ONCE to confirm and then press and
hold [M] Button 2 seconds to exit.
• Other setting please follow the “Camera setup and
program - Setting the Time Lapse Mode” above to set
the camera into TLS mode.
• Then slide the switch from TEST to CAM position and
close the front cover with lock.
Right now, the status display will count down 60 seconds for you
to leave the coverage area, and then camera will start the Time
Lapse Mode. And the unit will start capturing once it reaches
programmed start time, and stops at the end time.
To Next Page
Loading...