Facina VKPCCTV - Page 19

Facina_VKPCCTV_Instructions_Rev01
19
• Press [M] to confirm the camera’s operation is PIR
detection.
• Press [UP] or [DN] button until the word CAM and burSt
are blinking.
• Press [M] button ONCE to confirm the camera into still
image burst setting.
• Press [UP] or [DN] button to select the desired burst
setting (number of pictures per trigger).
• Press [M] to save your selection, then the CAM and T-O
(time out) will blink. Press [M] button to enter time out
setting or pressing and hold the [M] button 2 seconds to
exit.
Setting the Time of Video length in PIR mode:
Your camera can be programmed to record 5 ~ 600 seconds
(00:05-10:00 minutes) of video per trigger. The Video capture is
only workable under PIR mode.
• After set camera operated at PIR detection, press [M] to
confirm.
• Press [UP] or [DN] button until the word VIDEO and T are
blinking.
• Press [M] button ONCE to confirm the camera into video
recording time setting.
• Press [UP] or [DN] button to select the desired time
5~600 seconds (video recording time per trigger).
• Press [M] to save your selection, then the VIDEO and T-O
(time out) will blink. Press [M] button to enter time out