Facina VKPCCTV - Page 18

Facina_VKPCCTV_Instructions_Rev01
18
Setting the Image Resolution in PIR mode:
Your camera can be programmed to 3 different image
resolutions: “3 Stars” is 8MP, “2 Stars” is 5MP and “1 Star” is
2MP.
• Slide the switch to the TEST position from OFF and the
status display will show the camera’s current status.
• Press [M] button once to call out the program menu and
the word PIR will be blinking.
• Press [M] to confirm the camera’s operation is PIR
detection.
• Press [UP] or [DN] button until the word CAM and AES
(Resolution) are blinking.
• Press [M] button ONCE to confirm the camera into still
image resolution setting.
• Press [UP] or [DN] button to select the desired resolution.
• Press [M] to save your selection, then burSt (Burst shoot)
will blink. Press [M] to enter the burst shoot setting or
press and hold the [M] button 2 seconds to exit.
Setting the Burst Shoot in PIR mode:
Your camera can be programmed to shoot 1-10 pictures per
trigger.
• Slide the switch to the TEST position from OFF and the
status display will show the camera’s current status.
• Press [M] button once to call out the program menu and
the word PIR will be blinking.