21
16. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Battery connectors do
not spark when touched
together.
The charger is equipped with an
auto-start feature. It will not supply
current to the battery connectors
until a battery is properly
connected. The connectors will not
spark if touched together.
No problem; this is a normal
condition.
The charger will not turn on
when properly connected.
AC outlet is dead.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
I cannot select a language
on the display.
select a language:
(EN→→ FR→ ES→ IT)
.
No problem; this is normal.
display shows ANALYZING
BATTERY.
The charger needs to check the
condition of the battery.
charger is checking the condition
of the battery. This is normal.
the display shows CHARGE
ABORTED - BAD BATTERY.
The capacity of the battery is too
large for the charger.
The battery voltage is still below
amp rate.
The display shows
CONNECT CLAMPS.
The clamps are not making a good
connection.
The fuse is bad. Ring connectors
only.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the ring
connector.
The display shows
EXTERNAL BATTERY
VOLTAGE TOO HIGH.
The external battery voltage is more
than the unit with power supply
mode.
Replace the external battery.
Input ........................................................................................
Output ...........................................................................................
17. SPECIFICATIONS
18. LIMITED WARRANTY
To Next Page
Loading...
